Thread: Clutch related torque spec's

i found this over on DSMtalk
http://www.dsmtalk.com/forums/showthread.php?t=192782


Flywheel bolts-----------------------------------------94-101ft/lbs
Pressure plate bolts (ACT 2600 if it matters) -----------11-16ft/lbs
Trans to motor bolts-32-39 for the big ones and 22-25 for the rear one
Trans mount bolts 42 for mount to tranny--51 for the nut on the mount bolt
Transfer case bolts-----------------------------------43-58ft/lbs
Various driveshaft bolts (supports and yoke) 22-25 on rear flange-22-29 for carrier bearings
Front CV to hub nuts --------------------------------145-188ft/lbs
Strut to spindle bolts ----------------------------------80-101ft/lbs

ehh here is a few more non-clutch related, found over at the Busherforums http://buschurforums.com/vbforum/showthread.php?t=8548

Turbo-to-manifold bolts: 40-47
Exhaust manifold-to-head studs: 18-22
O2 sensor housing-to-downpipe studs: 29-43
O2 sensor housing-to-turbo bolts: 40-47
O2 sensor: 29-36
Oil banjo bolt: 20-25
Water banjo bolt: 25-36
Valve cover bolts: 2-3
Spark plug well cover bolts: 2-3
Oil drain plug: 25-33
Spark plugs: 15-21